BIQU is running another amazing giveaway to gift 13 of their fans with a brand new BIQU Hurakan 3D Printer. To enter in their latest BIQU Hurakan 3D Printer XMAS EVENT Giveaway grab your free entries by following few simple steps listed down below!
About BIQU Hurakan 3D Printer
The Biqu Hurakan has a build volume of 220 x 220 x 270 mm. While not the largest build volume ever, this should be plenty for a wide range of 3D printing use cases. A maximum hot end temperature of 260 °C and a maximum bed temperature of 100 °C, alongside a Bowden extruder, should get you printing with the usual suspect materials, such as PLA, ABS, PETG, and TPU.
Biqu also states the possibility of upgrading the stock extrusion system to a Biqu H2, which is a direct extruder that should give you enhanced performance with flexible materials (and it also means the max temperature capabilities will increase slightly). It’s currently unclear at this time if the machine has all the correct mounting holes for this upgrade, but we presume so.
Table of Contents
GIVEAWAY REQUIREMENTS
STEP 1 – Follow the link to a giveaway widget -> BIQU Hurakan 3D Printer XMAS EVENT Giveaway
STEP 2 – Log in to a giveaway widget with your Facebook, Twitter or email account.
STEP 3 – Finish the tasks listed in the widget to grab your free entries.
Bonus entries: Share your referral link with friends to get an additional 10 entries for each person who enters through the link.
- Not known how a winner is going to be contacted, probably by email and announced in a giveaway widget shortly after the giveaway ends.
GIVEAWAY END: December 31st, 2022
OPEN TO: WORLDWIDE
GIVEAWAY PRIZE
Entries > 50: Rubber duck+TMC2209*8
Entries > 100: add on Manta M8P+CB1
Entries > 150: add on HDMI 5
Entries > 200: add on H2 V2S Revo
Special gift for Entries = 222: BIQU HURAKAN 3D printer (*no add-on gifts above)
Entries > 222: Rubber duck+TMC2209*8+Manta M8P+CB1+HDMI 5+H2 V2S Revo
Good luck!